Утечки в системах жизнеобеспечения: причины, признаки и методы устранения

Why Fittings Leak Guide—Common Causes, Signs, And How To Check And Fix Leaks Leaks in life science fluidic systems can cause bubbles, pressure loss, fluid loss, and compromised analytical results. While a leaking fitting may seem like a small problem, connection failures can quickly disrupt an entire flow path. This guide explores the most common causes of fitting leaks and provides practical steps for identifying and resolving them. Improper assembly is one of the most frequent causes of leaks. Under- or over-tightening, incorrect tubing installation, angled connections, and reuse of single-use components can all prevent fittings from sealing properly. The guide also explains why fitting design must match the application, from low-pressure systems to demanding UHPLC environments where torque control, zero dead volume, and reliable sealing are essential. Chemical compatibility is another critical consideration. Incompatible materials can cause polymer creep, relaxation, cracking, swelling, or hardening, compromising both the fitting and its seal. Manufacturing tolerances and surface quality also matter, as inconsistent tubing dimensions, damaged ports, scratches, and other defects can create leak paths. Because leaks are not always immediately visible, the guide highlights common warning signs, including loss of flow or pressure, increasing pump pressure without flow, baseline noise, baseline drift, and visible fluid. It then provides troubleshooting steps, from checking tubing seating and tightening torque to inspecting sealing surfaces, receiving ports, and material compatibility. With the right fitting selection, proper assembly, and attention to materials and tolerances, many leak-related problems can be prevented. These practices help maintain reliable connections, minimize downtime, and keep fluidic systems performing consistently across demanding life science applications. Get unlimited access to: Enter your credentials below to log in. Not yet a member of Med Device Online? Subscribe today.