Рюкзак Titaner Voyager полностью изготовлен из аэрокосмического титана

Titaner Voyager Titanium Carry-On "Titanium" travel gear usually only uses titanium for trim because most manufacturers won't invest in the specialized tools it requires to use the material more broadly. Titaner, a Xi'an-based company with two decades of building aerospace-grade titanium products, is the rare manufacturer that applies grade 1 titanium to the Voyager's entire shell. The design skips zippers and drilled holes entirely, closing instead by latch. A hydrophobic coating layers over the metal's natural water resistance, so rain and spills run off rather than soak in. The case measures 20 inches, meets carry-on standards, and holds 37 liters, about 1.3 cubic feet. It weighs roughly 10.4 pounds. Titaner says the shell withstands three times the impact of a comparable aluminum case. The telescoping handle locks across 13 stages without a single hole drilled into it. All 32 wheels are modular, so a damaged wheel gets swapped individually instead of forcing a replacement of the whole case. Inside, dual-zone compression straps hold packed items in place, and the lining resists stains. A waterproof gear vault and a foldable modular gear bag are available as add-ons for camera and electronics storage. This metal was built for aerospace. Now it has to survive baggage claim.