Отсутствие экологического страхования может заставить клиента погасить миллионы за ликвидацию загрязнения

A 1% chance of contamination can leave the client funding the whole clean-up - and the broker's paperwork in front of a court Environmental By Environmental contamination is one of the few exposures where the client's loss and the broker's professional indemnity risk arrive in the same envelope. If a commercial client learns after a fire that their property policy will not fund the clean-up, the next question is rarely about the wording. It is about who read it. Many property policies now exclude the expenses associated with the removal of contaminated debris, the off-site contamination caused by the dispersal of toxic substances in fire-water run-off, and the consequential losses suffered by any third party. Environmental insurance sits outside the standard property placement, so those three exclusions can turn a routine claim into an uninsured liability and into a dispute about what was raised at renewal. "Without cover the financial viability or sustainability of any entity (big or small; built or otherwise) is 100% exposed to the full costs of remediation," said Anthony Saunders, partnership director for EnviroSure at Gow-Gates Insurance Australasia in Sydney. Listen next:  Why brokers can't ignore environmental risk anymore The underlying exposure is not speculative. The Cooperative Research Centre for Contamination Assessment and Remediation of the Environment (CRC CARE) estimates Australia has more than 160,000 potentially contaminated sites, of which only around 10% are remediated. Most sit in urban areas and include disused service stations, former industrial land and closed manufacturing sites - the ground beneath a great many of the warehouses, workshops and light industrial units currently sitting on brokers' books. The $6 million gap that outlived the business Australia already has its cautionary example, and it remains the reference point Saunders returns to. I n August 2005, a chemical factory at Narangba, north of Brisbane, burned down. Queensland Fire and Rescue Service fought the blaze with water. The water mixed with the factory's chemicals, ran off the site and soaked into the ground, contaminating both the land and neighbouring bushland. The site owner, Hamcor Pty Ltd, was placed under an obligation to remediate at a cost exceeding $9 million - far more than the land was worth. The property policy responded to the fire. It did not respond to the ground. Hamcor recovered $3 million under the policy taken out in its name, leaving roughly $6 million uninsured. What followed is the part brokers should read twice. Hamcor sued the fire service and lost, with the Supreme Court of Queensland finding statutory immunity applied; the Court of Appeal upheld that outcome in October 2015. Hamcor also sued two broking firms that had arranged liability cover for the operating company on the site. That claim failed as well. The court found the brokers' retainer ran to the operating entity, not to the landowner, and that awareness of a related company was not enough to create a duty of care to it. The brokers were not held liable. The point for a broker reading this is not that a court found fault. It is that a $6 million uninsured remediation bill produced a decade of litigation in which the broking file was examined in detail, and the outcome turned on the scope of the retainer and the quality of the instructions on record. Why environmental exclusions are widening The commercial logic behind the carve-out is straightforward. Remediation costs are difficult to reserve for, difficult to cap, and have a habit of arriving years after the triggering event. Fire-water run-off does not respect a site boundary. Once contaminants reach groundwater or a neighbouring property, the exposure stops being a property claim and becomes a third-party liability with an open-ended tail. The effect is a transfer of risk most policyholders have not registered, because it does not show up in the sum insured, the excess, or anything else a client routinely checks at renewal. Saunders puts the obligation on the intermediary in blunt terms. "Brokers MUST ask the question of the client 'what is the worst case possible scenario of risk, that 1:10,000 chance that could send your business broke?'" he said. "Then, articulate the risk to the insurer and seek an endorsement. Respond to the insured." That sequence - ask, articulate, respond - describes a file rather than a conversation. Each step leaves a document behind, which is what a broker is left holding if a client later says the exposure was never raised. Foreseen, fortuitous, and the gap in between Saunders argues the confusion sits in treating environmental exposure as a single problem. In his framing, there is what a business already knows about – existing contamination, compliance obligations, whose responsibility the clean-up is under a contract – and then there is the accidental event that could make all of it dramatically worse. He calls the first the foreseen and the second the fortuitous. Only the second is insurable, because insurance responds to what might happen, not to a bill already owed. His illustration is the 2011 Japanese earthquake. Designing a reactor to withstand a quake of a known magnitude treats risk as an engineering problem. A quake exceeding every previous recording is the part no design brief anticipated. Same hazard, two different categories and only one of them can be transferred to an insurer. The practical failure, on his account, is that nobody owns the second category. Environmental risk managers deal with the known problem and assume the accidental event has been covered by the broker. Often it has not. His further warning is that a risk assessment may not identify environmental risk at all, and that plenty of professionals present as environmental experts without holding a licence to advise on or insure pollution risk. He is equally direct about the reflex response brokers hear when the subject comes up. Raise environmental insurance and, before it has even been costed, the answer is that it is too expensive. Saunders argues the premium is not the obstacle. The cost sits in the environmental security measures a client must put in place to satisfy an insurer's compliance requirements - and going without transfers that cost nowhere, it simply leaves it with the client. His view of the alternative is unsentimental: self insurance, he wrote, invites reckless behaviour. What to check before the renewal conversation Environmental insurance is not priced the way most covers on a broker's book are priced. There is no sum insured to work from, because the loss is not the building. An environmental consultant estimates what remediating the site would cost after a fire, and the premium is set against the probability of that fire occurring. That is where the client conversation usually goes wrong. A 1% probability sounds like a 1% problem, so the cover looks like an expense rather than a transfer. But the probability and the exposure are two different numbers. The first is small. The second is the entire remediation bill, and without a policy it sits with the client. "Without environmental insurance, even if the chance of occurrence is 1% the entity will still be exposed to 100% of the Risk Adjusted Environmental Damage," Saunders said. Some occupancies carry materially more of this exposure than others. The obvious ones are anything storing fuels, solvents, chemicals, batteries or large volumes of plastics – but cold storage, waste handling, panel shops and agricultural chemical resellers belong on the list too, because the stock itself becomes the contaminant once it burns. Four practical checks before that conversation: 1. Read the debris removal clause, not the heading. Many wordings cover debris removal but carve out contaminated debris. The distinction is a single adjective and it is the whole exposure. 2. Establish whether the pollution exclusion is absolute or sudden-and-accidental. An absolute exclusion leaves nothing behind for fire-water run-off. Confirm which one the client is holding. 3. Ask what sits under and next to the site. Prior land use, groundwater proximity and the neighbouring occupier determine whether a contained incident becomes a third-party claim. Clients on former industrial land carry materially more risk and rarely know it. 4. Confirm who the retainer covers. Where a client trades through one entity and owns the site through another, put in writing which entity you act for and which policies respond to each. Hamcor turned on precisely that distinction. None of this happens by default. Environmental cover is a specialist placement and it will not appear on an SME schedule unless someone puts it there, which is why the gap has persisted for as long as it has. And for brokers, the exposure is not the client's contamination risk. It is what the file shows about whether the question was ever asked. Related Stories LATEST NEWS INSURANCE NEWS Broker fee transparency fight moves outside the Code review CONSTRUCTION & ENGINEERING Industrial sums insured fall short on site clearance CONSTRUCTION & ENGINEERING Australia's data centre boom: why insurers need to move as fast as the builders LEGAL INSIGHTS Review panel lifts Allianz claimant's bus-phobia impairment to 4% INSURANCE NEWS Brokers need to look beyond CTP cover after serious injuries